• EEVblog #536 – HP35670A DSA Repair


    Dave repairs a HP 35670A Dynamic Signal Analyser. Well, kinda…

    Forum HERE

    Be Sociable, Share!

      About EEVblog

      Check Also

      EEVblog #846 – Solar Panel Micrometeorite Impact!

      EEVblog #846 – Solar Panel Micrometeorite Impact!

      Dave uses a microscope to examine the shattered LG Mono-X solar panel. Was it a ...

      • JRAG

        Hi there Dave,
        Could it be that there is a problem with the I2C memory, and if that device stores the cal data results in calibration failure?
        And the cause of all those failed ADC tests could be because there is no cal data.
        Well, it’s just a guess. Hope it helps.

        Nice video, as always 😉

        • http://www.eevblog.com EEVblog

          Possible, but I doubt it. I think there are likely more PSU issues on the other boards.

      • chippy

        As the power supply went out and you tinkered around with it, you found that the primary side does not work.
        I was thinking all the time, why the heck does he not check the Fuse ?
        So I really hope you checked the Fuse ?

        Maybe the Instrument is still 220V vintage and your Sockets get 250V out. That might be a reason for the fuse to blow. (or for the power Supply to die.)

      • spaceman

        Why can’t those people that use them fix them???????????????

        • http://www.eevblog.com/ Dave Jones

          Some things are beyond economical repair. A bad PSU can take out dozens of chips, even custom ones.

      EEVblogLogo