Alitum 14 CAMtastic errors

[SparkFly]

Hi,

I'm working on a design (excuse messy areas) and was curious as to what the final gerber outputs would look like. I went through Alitum 14's Gerber generator and viewed the top copper layer (.GTL) in CAMtastic. However I notice that it seems to have duplicated other component layers, such as top silkscreen, on this layer too! I noticed that this only occurred on layers built using the IPC compliant wizard tool. I've attached an example below.

Is this a simple rendering bug? I've noticed the viewer isn't terribly great. Or is this a 'real' problem?

Many thanks for your time help, I appreciate it very much.

[T3sl4co1l]

Uh, well, didja check the library if it actually looks like that or what?   'Cuz once it's generated, it's just another library.

Tim

[SparkFly]

I've just figured it out... Should've held fire on the forum post... Apologies.

Turns out I shouldn't asked it to plot mechanical layers. Everything looks good now.

Thanks for the reply all the same T3sl4co1l.