Author Topic: altium14  (Read 4521 times)

0 Members and 1 Guest are viewing this topic.

Offline ant17Topic starter

  • Regular Contributor
  • *
  • Posts: 95
altium14
« on: December 18, 2013, 11:31:55 pm »
hi i have just stared using this and found that when i try to make a simple circuit i  get the error no signal pin has no driver could someone help
 

Offline free_electron

  • Super Contributor
  • ***
  • Posts: 8515
  • Country: us
    • SiliconValleyGarage
Re: altium14
« Reply #1 on: December 19, 2013, 12:25:14 am »
you have a floating input somewhere.
doubleclick the error ant it will tell you where
Professional Electron Wrangler.
Any comments, or points of view expressed, are my own and not endorsed , induced or compensated by my employer(s).
 

Online JDubU

  • Frequent Contributor
  • **
  • Posts: 438
  • Country: us
Re: altium14
« Reply #2 on: December 19, 2013, 06:25:59 am »
If you want the pin to float without a driving source on it, place the "NO ERC" (red X) symbol on it instead of a wire end.  It will prevent the warning.
 

Offline hyprfrcv

  • Newbie
  • Posts: 5
  • Country: us
Re: altium14
« Reply #3 on: April 23, 2018, 04:43:27 pm »
This error appears in Altium Designer when working with free schematics. If you add the schematics into a project, the error dissapears.

It is possible to discard this error working with free schematics?.
 


Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf