changing size of component pad

[mov-jump]

Hello
I designed this board and print it but I realized that size of pads are too small and all of them will be covered in the drilling step.
Now I wanna resize them (I know how can I resize but) If they become bigger then they would be so close to each other and the short circuit might be happen or the way of printing board will be difficult.
How can I resize then in order to have not these kind of error ?

[armandas]

Only increase one dimension of the pad (X or Y) to make them oval?

[mov-jump]

Only increase one dimension of the pad (X or Y) to make them oval?

Great   

[mov-jump]

Who have a good reference for manual routing tricks? I am addicted to Auto Routing 

[DTJ]

What is this autorouting thing of which you speak? 

[mov-jump]

What is this autorouting thing of which you speak? 

From Menu (Auto Route)

[mov-jump]

Another question about pads :

I used 40P6 footprint that is in correct size of packaging which mentioned in datasheet but when I print my design (the picture which I uploaded) and wanna to fix atmega16 pin size to pads on paper printed >>> there is about 100Mil difference between them.!!!
How can i fix this problem about difference between footprint in computer and printed version of footprint on paper.?