« previous next »
Pages: [1]   Go Down

Author Topic: Overstanding Components!?  (Read 3448 times)

0 Members and 1 Guest are viewing this topic.

Offline x18Topic starter

  • Contributor
  • Posts: 23
Overstanding Components!?
« on: October 29, 2011, 07:34:19 pm »
hi,

how do I design pcbs with overstanding components? like the one in the picture without getting  an error at the design rule check?
what do I have to do with those overstanding components to create a clean layout?

greetings.
Logged
 

Offline JuKu

  • Frequent Contributor
  • **
  • Posts: 566
  • Country: fi
    • LitePlacer - The Low Cost DIY Pick and Place Machine
Re: Overstanding Components!?
« Reply #1 on: October 29, 2011, 08:33:51 pm »
You either ignore the error or make a rule that targetes just that component or footprint.
Logged
http://www.liteplacer.com - The Low Cost DIY Pick and Place Machine
 

Offline shadewind

  • Frequent Contributor
  • **
  • Posts: 329
Re: Overstanding Components!?
« Reply #2 on: October 31, 2011, 06:40:53 pm »
Seems like your component is outside of its room. Expand the room to extend beyond the board edge. It seems like this is what causes the error.
Logged
 
Pages: [1]   Go Up
« previous next »

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf

 


EEVblog Main Site EEVblog on Youtube EEVblog on Twitter EEVblog on Facebook EEVblog on Odysee