« previous next »
Pages: [1]   Go Down

Author Topic: Pad and vía problem when generate PCB in PCB BOARD WIZARD  (Read 1783 times)

0 Members and 1 Guest are viewing this topic.

Offline FullRock66Topic starter

  • Contributor
  • Posts: 14
  • Country: cl
Pad and vía problem when generate PCB in PCB BOARD WIZARD
« on: June 13, 2017, 06:43:43 pm »
HI folks!!! I have a strange problem, i was trying to create a custom PCB, so i use the PCB BOARD WIZARD, but when the board was generated, when i put a PAD, is not posible to see hole designator or modify Hole size
Logged
 

Offline FullRock66Topic starter

  • Contributor
  • Posts: 14
  • Country: cl
Re: Pad and vía problem when generate PCB in PCB BOARD WIZARD
« Reply #1 on: June 13, 2017, 09:45:47 pm »
Problem solved, error is between the PC and the chair.
Logged
 

Offline Auciele

  • Contributor
  • Posts: 13
  • Country: fr
Re: Pad and vía problem when generate PCB in PCB BOARD WIZARD
« Reply #2 on: June 14, 2017, 11:45:08 am »
And what was it? i'm curious
Logged
Electronic engineer - Altium 10.1377.27009
 

Offline FullRock66Topic starter

  • Contributor
  • Posts: 14
  • Country: cl
Re: Pad and vía problem when generate PCB in PCB BOARD WIZARD
« Reply #3 on: June 20, 2017, 08:21:46 pm »

The problem was that in the Board Layer & Colors editor, they were not selecting the PAD an Holes, that's why they could not see, it was very simple, but it annoyed me a couple of hours. Thanks for the reply.
Logged
 
Pages: [1]   Go Up
« previous next »

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf

 


EEVblog Main Site EEVblog on Youtube EEVblog on Twitter EEVblog on Facebook EEVblog on Odysee