« previous next »
Pages: [1]   Go Down

Author Topic: Right angle SMA Connector - Altium Designer  (Read 4590 times)

0 Members and 1 Guest are viewing this topic.

Offline docmurTopic starter

  • Regular Contributor
  • *
  • Posts: 80
Right angle SMA Connector - Altium Designer
« on: August 23, 2014, 05:37:42 pm »
Does anyone know where to get a right angle SMA connector?   I want to add a stub antenna to my design.
Logged
 

Offline Precipice

  • Frequent Contributor
  • **
  • Posts: 403
  • Country: gb
Re: Right angle SMA Connector - Altium Designer
« Reply #1 on: August 23, 2014, 05:51:32 pm »
RS? Farnell? Pretty much any of the catalogue disties do them, or ebay if you want to chance your luck a bit on quality.
If you get a TE one, then the 3D models that TE supply are good. Should take about 5 minutes, tops, to make a footprint.
Logged
 
Pages: [1]   Go Up
« previous next »

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf

 


EEVblog Main Site EEVblog on Youtube EEVblog on Twitter EEVblog on Facebook EEVblog on Odysee