Hi folks,
is it possible to create a table of contents automatically on e.g. the first sheet of the schematic?
I'm thinking of Altium writing down automatically the schematic sheet names with their page number behind them.
Another question:
Is there a possibilty to change how Altium names the bookmarks in the generated "Smart PDF"?
E.g. one sheet in my project is called "[02] - Block Diagram.SchDoc".
In the PDF the bookmark "[02] - Block Diagram.SchDoc("[02] - Block Diagram")" is created.
It would be nice if you could change the naming settings to e.g. "[02] - Block Diagram".
Currently it looks really messy
Thank you in advance.
Kind regards