Author Topic: tent only one side of a via?  (Read 1932 times)

0 Members and 1 Guest are viewing this topic.

Offline Pack34Topic starter

  • Frequent Contributor
  • **
  • Posts: 753
tent only one side of a via?
« on: May 09, 2017, 05:47:02 pm »
The purpose of this is for test points.

On a BGA fan-out I want to drop a via for an array of unused pins for this prototype run so I have the flexibility to hack and slash afterwards. To mitigate shorts, I'd like to have the vias/test points tented on the BGA side and exposed on the reverse.

On the properties menu of the via I can see the Top Solder and Bottom Solder layers listed but I'm not seeing an option to modify these individually.
 

Offline Pack34Topic starter

  • Frequent Contributor
  • **
  • Posts: 753
Re: tent only one side of a via?
« Reply #1 on: May 09, 2017, 06:01:30 pm »
I was looking for a textbox to specify the solder mask diameter, but didn't notice the check boxes on the bottom right to force tenting on the bottom or top.

This issue is resolved.
 


Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf