EEVblog Electronics Community Forum

Electronics => PCB/EDA/CAD => Altium Designer => Topic started by: ali_asadzadeh on August 13, 2017, 06:00:47 am

Title: What did I wrong in altium, cause to route over everything!
Post by: ali_asadzadeh on August 13, 2017, 06:00:47 am

Hi,
I do not know why in this design, altium just ignores every net and object and would route on every thing! It's like paint and a pencil |O |O

Title: Re: What did I wrong in altium, cause to route over everything!
Post by: ali_asadzadeh on August 13, 2017, 06:11:29 am

Nope,It got just stupid, and I have a lot of time on this design! |O |O

Title: Re: What did I wrong in altium, cause to route over everything!
Post by: ali_asadzadeh on August 13, 2017, 06:33:34 am

I have Deleted all the rules and create them again, the problem is now solved! :o :o

Title: Re: What did I wrong in altium, cause to route over everything!
Post by: T3sl4co1l on August 13, 2017, 02:37:36 pm

Did you cycle SHIFT+R?

Tim

Title: Re: What did I wrong in altium, cause to route over everything!
Post by: ali_asadzadeh on August 14, 2017, 05:10:58 am

yes... |O

Title: Re: What did I wrong in altium, cause to route over everything!
Post by: free_electron on August 22, 2017, 03:19:53 pm

shift-r. you were in 'ignore obstacles mode'
in the system preferences you can turn that mode off ( you can select the possible modes that are allowed. )