OK, so after watching the videos, I like the product. However, it seems that he has it locked down to about 100w, however the components are capable of much note than that, just wondering if I mossing something, or if I remove the Max limit, and can sink away the heat fast enough, will it work for what I'm chasing? I can't see why it won't, as the FETs are 100v and well over the current rating I am after at 30v.
EDIT:
i wrote that at work, i got home and looked at the specs for the fets, and they are capable of 350W each, but mentioned in the videos is that they will de-rate to aprox 1/2 - 2/3 of that value when near full load and temp, so assuming that i can dissipate the 600W+ of heat wouldn't that mean that i can have it safely pulling approx 2/3 of total rated capacity? so about 900W? give or take a bit.
I also noticed that he paralelled up 4 fets, by using a low value resister on the drain pin of the fets, which was my thought, as wouldn't the electron balance themselves out amoungst the fets?
i hope that makes sense.
Jason
Jason