.EPS pcb layout from Eagle files?

[Chris Wilson]

I have two Eagle files and need an .EMS file from them. I do not have Eagle. I just want the file to print the transparency to etch a couple of boards. Can someone tell me if the files attached will convert to produce an .EMS file and what i need to do this please? Or if it's dead straightforward for an Eagle user, maybe they could convert to.EMS and post it up or mail it me....    

Thanks!

[kc9qvl]

If you are going to etch yourself. Just print the brd file as a mirrored black pdf.

[Chris Wilson]

Thanks, I'll download it again, but if it had errors would the zip have even opened?

[kc9qvl]

Eagle is complaining about erc errors. not set junctions. Is this supposed to be a 2 sided board? ground plane on top?

[Chris Wilson]

I thought it was a single sided board. Let me find the link....

This was it:

http://www.feedpopular.com/read/aHR0cDovL2NpcmN1aXRzZGl5LmNvbS9sbTMxNy1yZWd1bGF0b3ItYm9hcmQtcGNiLW1ha2luZy8=/TE0zMTcgcmVndWxhdG9yIGJvYXJkIFBDQiBtYWtpbmcgfCBDaWN1aXRzIERJWQ==

Thanks.

[kc9qvl]

Ok for transparency method

[Chris Wilson]

Ok for transparency method

That was really good of you, many thanks. If I print at 100% size straight from the .pdf file, should the image size be correct? Hole spacing for the header connectors and LM317 seem correct at 100%

Thanks again!