EEVblog Electronics Community Forum
Electronics => Beginners => Topic started by: barak198 on December 17, 2015, 11:35:05 pm
-
I am sampling the voltage from a signal generator in CH1
and the voltave over a resistor (10k) in CH2
there is nothing else in this circuit
the scope shows the waves as if there is a phase shift !
what is the problem ?
thank you
-
got it !!
the invert button was on...
-
Glad to see I'm not alone. |O
-
I am still learning how to use it :)
-
Once I spent more than one hour trying to find out why my scope would not give me the trace that I was expecting, instead was giving me this noise and I could see the 60Hz background noise. I pushed buttons, check my source, click the "auto set" several times. I was about to give up when.... ta ta ta taaaam :-\ The probe that I was using to probe the circuit was not connected to the scope, I had grabbed a spare probe!! |O