« previous next »
Pages: [1]   Go Down

Author Topic: Hot air and Preheater jumping off point?  (Read 1654 times)

0 Members and 1 Guest are viewing this topic.

Offline SzewczykmTopic starter

  • Regular Contributor
  • *
  • Posts: 55
Hot air and Preheater jumping off point?
« on: January 11, 2013, 08:53:27 pm »
I purchased a hot air station and a board pre-heater.  When using my regular soldering iron, I set it at 600F and then go up or down as I might need to.  Normally it stays there.

I'm wondering what the same might be for the pre-heater and hot air station?  Is there a general jumping off point you use?
Logged
 
Pages: [1]   Go Up
« previous next »

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf

 


EEVblog Main Site EEVblog on Youtube EEVblog on Twitter EEVblog on Facebook EEVblog on Odysee