« previous next »
Pages: [1]   Go Down

Author Topic: Mount power relay on vectorboard  (Read 1619 times)

0 Members and 1 Guest are viewing this topic.

Offline LegionTopic starter

  • Frequent Contributor
  • **
  • Posts: 360
Mount power relay on vectorboard
« on: April 05, 2014, 06:27:03 am »
I picked up this power relay from digikey the other day: http://www.digikey.ca/product-search/en?WT.z_header=search_go&lang=en&site=ca&keywords=t9as1d12-5&x=10&y=10&formaction=on
I didn't realize the pin pitch doesn't match my vectorboard. Is there some kind of adapter socket? Kind of like a DIP socket for relays? I'm not sure to stably mount it to the board.
Logged
 

Offline LegionTopic starter

  • Frequent Contributor
  • **
  • Posts: 360
Re: Mount power relay on vectorboard
« Reply #1 on: April 05, 2014, 07:36:07 pm »
Didn't realize sparkfun has a PCB for it. Ordered a few of them. Should be easier than trying to jury-rig the relay to a protoboard.
Logged
 

Offline theatrus

  • Frequent Contributor
  • **
  • Posts: 352
  • Country: us
Re: Mount power relay on vectorboard
« Reply #2 on: April 06, 2014, 03:46:48 am »
In the past I've drilled the board and used wires to join it to pads.
Logged
Software by day, hardware by night; blueAcro.com
 
Pages: [1]   Go Up
« previous next »

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf

 


EEVblog Main Site EEVblog on Youtube EEVblog on Twitter EEVblog on Facebook EEVblog on Odysee