Hi,
Sorry if this is in the wrong section... I am after a bit of advice on how to reprogram a MSP55LV100S chip. I believe these are NVPROMs, which I think I should be able to reprogram with the correct hardware. I cannot find a data sheet for this device so I am a bit clueless where to begin.
I have one of these on a PCB, and I am sure its corrupted - generating noisy sound on Neo Geo MVS. I can remove the chip but not sure how to go about reprogramming it. Does anyone know of a cost effective way / programmer to do this?
I've got a couple of EPROM programmers but they are for 40 pin or less chips, and I am guessing this particular chip could have some serial interface or something for programming? I've also got a USB 3 in 1 JTAG programmer but not sure if that could be used or not without understanding how this chip works, or more specifically the pin out etc.