Hello,
I am finally going to complete my 8-bit breadboard computer ( just the control logic left ). I am not dealt with this issue of power distribution across the breadboard. I have tried the following method and would love to hear some recommendations to it :
I took my cell-phone charger | OUTPUT - 5.00 V 2A | and connected it onto the breadboard by soldering with some header pins. The LED's did glow somewhat better than before, So I tried connecting another power supply which I got it additionally when purchasing the breadboard. Its called a 'Power Module' and it gives me about 5V and then the LED's glow a lot better but could still be improved.....