Hi All, this seems to be very simple question and I already did some research about it but this one question that I still can't find very definitive answer.
I have MCP601, it is powered by single supply and wired into voltage follower/buffer configuration. On non-inverting input I have a piezo disk and when I tap piezo disk it sends waveform into Op Amp's input and apparently even though waveform has both, negative and positive components, on Op Amp's output I can only see the positive half of waveform, which is good and what I need. What are the op-amps input voltage limits? For example if Op-Amp is powered by 3.3v, can input voltage be 5v, 10v? Can it be -5 or -10v, is it a simple matter of Op-amp just not being able to make output voltage high/low enough, it I can actually damage it and need to protect inputs from overvoltage?