« previous next »
Pages: [1]   Go Down

Author Topic: USB Host Shield Error  (Read 4448 times)

0 Members and 1 Guest are viewing this topic.

Offline MasterSnipesTopic starter

  • Newbie
  • Posts: 9
USB Host Shield Error
« on: March 11, 2015, 12:57:54 am »
Hey there! I recently got a USB Host Shield from Circuits@Home and I ran the test program and here are the results I got:


Circuits At Home 2011
USB Host Shield Quality Control Routine
Reading REVISION register... Die revision invalid. Value returned: 00
Unrecoverable error - test halted!!
0x55 pattern is transmitted via SPI
Press RESET to restart test

 I also ran the PS3BT sketch in an attempt to connect a PS3 controller to the Arduino via bluetooth but I got "OSC did not start" multiple times after once when I got "PS3 Bluetooth library" which made me all like  :scared: and I was filled with joy but that quickly faded as I got "OSC did not start" very soon after that.

I feel like  |O |O |O

SomebodyPleaseHELP!
Logged
 

Offline mazurov

  • Frequent Contributor
  • **
  • Posts: 524
  • Country: us
Re: USB Host Shield Error
« Reply #1 on: March 11, 2015, 01:02:09 am »
Have you soldered 2x3 header?
Logged
With sufficient thrust, pigs fly just fine - RFC1925
 

Offline MasterSnipesTopic starter

  • Newbie
  • Posts: 9
Re: USB Host Shield Error
« Reply #2 on: March 11, 2015, 01:59:18 am »
Yes, I have but what would a good connection look like?
Logged
 

Offline mazurov

  • Frequent Contributor
  • **
  • Posts: 524
  • Country: us
Re: USB Host Shield Error
« Reply #3 on: March 11, 2015, 02:12:14 am »
A good picture of a soder job would be helpful. Also, try running Arduino from external power source.
Logged
With sufficient thrust, pigs fly just fine - RFC1925
 

Offline MasterSnipesTopic starter

  • Newbie
  • Posts: 9
Re: USB Host Shield Error
« Reply #4 on: March 11, 2015, 11:25:42 pm »
How would I know if the USB Host Shield worked or not? If I am running from an external power source.
Quote from: mazurov on March 11, 2015, 02:12:14 am
A good picture of a soder job would be helpful. Also, try running Arduino from external power source.
Logged
 

Offline mazurov

  • Frequent Contributor
  • **
  • Posts: 524
  • Country: us
Re: USB Host Shield Error
« Reply #5 on: March 12, 2015, 12:05:16 am »
Take a picture of your solder job and post it here.
Logged
With sufficient thrust, pigs fly just fine - RFC1925
 
Pages: [1]   Go Up
« previous next »

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf

 


EEVblog Main Site EEVblog on Youtube EEVblog on Twitter EEVblog on Facebook EEVblog on Odysee