I'm trying to move 2 of my 6 Mining computers from my laundry room to my garage.
All 6 computers run fine when powered by a dryer socket (240v 30a)
According to my Killawatt, the 2 computers pull 1500W (0.99 PF) in my garage.
The whole garage, and only the garage is on a single 20A breaker (120V)
When I try to connect the computers via powerline adapter I trip my breaker within 1hr.
But if I unplug everything except the computers, and switch them to Wifi, the breaker never trips.
The breaker is just a standard 20A breaker.
The wall socket is a GFI (The gfi isn't tripping, the breaker is)
So it looks like, either a power line adapter, an AC line filter, or a power strip is tripping my breaker.
Which of those would make the most sense?
So far I have not had the breaker trip while opening/closing the 1/3hp garage door (W/ all the computers running too)