Author Topic: EEVblog #1109 - Spectrum Analyser Design Walk-through  (Read 473 times)

0 Members and 1 Guest are viewing this topic.

Offline EEVblog

  • Administrator
  • *****
  • Posts: 26344
  • Country: au
    • EEVblog
EEVblog #1109 - Spectrum Analyser Design Walk-through
« on: July 24, 2018, 09:15:25 am »
A step-by-step walk-though of a typical modern low cost 3GHz "All Digital IF" spectrum Analyser design.

 

Online JS

  • Frequent Contributor
  • **
  • Posts: 663
  • Country: ar
Re: EEVblog #1109 - Spectrum Analyser Design Walk-through
« Reply #1 on: July 24, 2018, 01:05:11 pm »
At the end you mentioned nyquist, but as its already a band pass filter could very well be doing oversampling, and rhe IF being centered at 30MHz or 50MHz makes a ton of sense, as it could be at 10MHz and nyquist it is.. Checking the ADC datasheet should tell how high oversampling can go, usually limited by the sampling time but also the use of decimation and anti aliasing filters.

JS

If I don't know how it works, I prefer not to turn it on.
 


Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf