Author Topic: Post a guess on the min starting voltage for this brushed DC motor  (Read 5164 times)

0 Members and 1 Guest are viewing this topic.

Offline Brumby

  • Supporter
  • ****
  • Posts: 12288
  • Country: au
Re: Post a guess on the min starting voltage for this brushed DC motor
« Reply #25 on: May 23, 2018, 01:39:57 am »
I forgot to ask .... is this with or without a Batteriser?
 

Offline PsiTopic starter

  • Super Contributor
  • ***
  • Posts: 9889
  • Country: nz
Re: Post a guess on the min starting voltage for this brushed DC motor
« Reply #26 on: May 23, 2018, 10:21:42 am »
Gyro  75mV
Electro Detective 0.050mV
TwoOfFive 50mV
Brumby 82mV
schmitt trigger 94.5mV
NiHaoMike  133.7mV
Hero999  40mV
amyk  67mV
Tomorokoshi 42mV
JohnnyMalaria 0mV
ez24 1550mV
BrianHG  -65mV


So, results are in, and im calling it a tie between Gyro (75mV) and amky (67mV).
Mainly because i stuffed up and let the cat out of the bag.

BrianHG gets some points for guessing perfectly 180deg out of phase.

Video



« Last Edit: May 23, 2018, 12:19:31 pm by Psi »
Greek letter 'Psi' (not Pounds per Square Inch)
 
The following users thanked this post: ez24

Offline Gyro

  • Super Contributor
  • ***
  • Posts: 9410
  • Country: gb
Re: Post a guess on the min starting voltage for this brushed DC motor
« Reply #27 on: May 23, 2018, 11:22:48 am »
Yay, thanks (congrats to amyk and BrianHG). ;D

It's still impressive to see those motors turning so slowly.
Best Regards, Chris
 

Offline PsiTopic starter

  • Super Contributor
  • ***
  • Posts: 9889
  • Country: nz
Re: Post a guess on the min starting voltage for this brushed DC motor
« Reply #28 on: May 23, 2018, 08:08:07 pm »
Yeah.

Make sure you checkout the end of the video. I included some closeup shots of the commutator rotating.
Greek letter 'Psi' (not Pounds per Square Inch)
 
The following users thanked this post: Gyro

Offline Brumby

  • Supporter
  • ****
  • Posts: 12288
  • Country: au
Re: Post a guess on the min starting voltage for this brushed DC motor
« Reply #29 on: May 24, 2018, 02:39:22 am »
Dang, I went high .... should have gone low.

Yes, I am using Gyro's figure as my reference.   :-[
 

Offline Ampera

  • Super Contributor
  • ***
  • Posts: 2578
  • Country: us
    • Ampera's Forums
Re: Post a guess on the min starting voltage for this brushed DC motor
« Reply #30 on: May 24, 2018, 02:47:48 am »
I'm happy with my guess, I wasn't that far off.

I forget who I am sometimes, but then I remember that it's probably not worth remembering.
EEVBlog IRC Admin - Join us on irc.austnet.org #eevblog
 


Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf