Unknown pin error

[Simon]

When I try to bring may schematic design into the PCB I find that a newly created capacitor gives an error. "unknown pin" well the pins are 1 and 2 in both the symbol and footprint and I have use both before so as always I am baffled. But then this is CS!!!

[voltsandjolts]

Hi Simon,
I see you have the same post on the E14 forum and you have tracked down your mistake.
Just posting this here so nobody wastes their time replying.

https://www.element14.com/community/thread/65016/l/unknown-pin-error

[Simon]

As for it being "my mistake" well, I took a copy of a template symbol that is set to standard, so how the copy was set to mechanical I don't know.....