Author Topic: why the red crosses all over the trace  (Read 850 times)

0 Members and 1 Guest are viewing this topic.

Offline Simon

  • Global Moderator
  • *****
  • Posts: 11634
  • Country: gb
  • Did that just blow up? No? might work after all !!
    • Simon's Electronics
why the red crosses all over the trace
« on: August 15, 2017, 04:57:14 pm »
Attached is a screen print, I am confused about the trace I have manually placed that has red circles with crosses "punched" in them all over it. What have I done wrong now ?
https://www.simonselectronics.co.uk/shop New stock now in of EEVblog Brymen 235 and uCurrent Gold, Now selling a selection of Probe Master probes
 

Online tautech

  • Super Contributor
  • ***
  • Posts: 11970
  • Country: nz
    • Taupaki Technologies Ltd.
Re: why the red crosses all over the trace
« Reply #1 on: August 15, 2017, 05:25:46 pm »
It's a DRC violation.
If you hover the mouse over it there should be some indication as to why.
It could be track width, clearance, unassigned net, bridged solder mask etc
Avid Rabid Hobbyist & NZ Siglent Distributor
 

Offline Simon

  • Global Moderator
  • *****
  • Posts: 11634
  • Country: gb
  • Did that just blow up? No? might work after all !!
    • Simon's Electronics
Re: why the red crosses all over the trace
« Reply #2 on: August 15, 2017, 09:51:07 pm »
Ah yes it was because I had a maximum trace width set smaller than I made that trace.
https://www.simonselectronics.co.uk/shop New stock now in of EEVblog Brymen 235 and uCurrent Gold, Now selling a selection of Probe Master probes
 


Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf