« previous next »
Pages: [1]   Go Down

Author Topic: why the red crosses all over the trace  (Read 2664 times)

0 Members and 1 Guest are viewing this topic.

Offline SimonTopic starter

  • Global Moderator
  • *****
  • Posts: 17816
  • Country: gb
  • Did that just blow up? No? might work after all !!
    • Simon's Electronics
why the red crosses all over the trace
« on: August 15, 2017, 06:57:14 am »
Attached is a screen print, I am confused about the trace I have manually placed that has red circles with crosses "punched" in them all over it. What have I done wrong now ?
Logged
 

Offline tautech

  • Super Contributor
  • ***
  • Posts: 28379
  • Country: nz
  • Taupaki Technologies Ltd. Siglent Distributor NZ.
    • Taupaki Technologies Ltd.
Re: why the red crosses all over the trace
« Reply #1 on: August 15, 2017, 07:25:46 am »
It's a DRC violation.
If you hover the mouse over it there should be some indication as to why.
It could be track width, clearance, unassigned net, bridged solder mask etc
Logged
Avid Rabid Hobbyist
Siglent Youtube channel: https://www.youtube.com/@SiglentVideo/videos
 

Offline SimonTopic starter

  • Global Moderator
  • *****
  • Posts: 17816
  • Country: gb
  • Did that just blow up? No? might work after all !!
    • Simon's Electronics
Re: why the red crosses all over the trace
« Reply #2 on: August 15, 2017, 11:51:07 am »
Ah yes it was because I had a maximum trace width set smaller than I made that trace.
Logged
 
Pages: [1]   Go Up
« previous next »

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf

 


EEVblog Main Site EEVblog on Youtube EEVblog on Twitter EEVblog on Facebook EEVblog on Odysee