EEVblog Electronics Community Forum
Electronics => PCB/EDA/CAD => Circuit Studio => Topic started by: Simon on August 15, 2017, 06:57:14 am
-
Attached is a screen print, I am confused about the trace I have manually placed that has red circles with crosses "punched" in them all over it. What have I done wrong now ?
-
It's a DRC violation.
If you hover the mouse over it there should be some indication as to why.
It could be track width, clearance, unassigned net, bridged solder mask etc
-
Ah yes it was because I had a maximum trace width set smaller than I made that trace.