EEVblog Electronics Community Forum
Products => Crowd Funded Projects => Topic started by: FrankenPC on April 02, 2015, 06:26:09 am
-
Why not just make a Hakko/weller tip set?
https://www.kickstarter.com/projects/1654851065/retouch3d-a-brand-new-way-to-finish-3d-prints (https://www.kickstarter.com/projects/1654851065/retouch3d-a-brand-new-way-to-finish-3d-prints)
"World's first heated tool to finish 3D prints with variable heat and interchangeable heads designed for specific 3D retouching tasks."
-
i've done this from many months ago, ie finishing up 3dprint output with bundled flat tip temp control china 852AD. just make sure you sacrifice that tip for the purpose only because after that it wont be good for normal soddering without extensive abs ash deposit cleanup.
-
hakko make a knife tip. T18-K, 10$!
www.amazon.com/dp/B004ORB8MY (http://www.amazon.com/dp/B004ORB8MY)