EEVblog Electronics Community Forum

Electronics => PCB/EDA/CAD => DIPtrace => Topic started by: Cloud on March 11, 2016, 08:45:38 pm

Title: Opening file and exporting PDF (or gerber)
Post by: Cloud on March 11, 2016, 08:45:38 pm

Hello,
I have found this nice project for reflow controller, but the problem is, that files are in DIP trace format and since I am not using dip trace, I would like to ask some one to open them and export the PDF or gerber. I would need files for TOP copper, BOTTOM copper and solder mask layer (and if its possible BOM).

Files are here: https://github.com/rocketscream/Reflow-Oven-Controller

Thank you very much

Title: Re: Opening file and exporting PDF (or gerber)
Post by: HwAoRrDk on March 13, 2016, 02:38:45 am

Here you go, see attached. I exported Gerbers for everything, including silk screen, etc. Let me know if you need anything else (i.e. paste layers). BOM is in CSV format.

Title: Re: Opening file and exporting PDF (or gerber)
Post by: Cloud on March 13, 2016, 05:04:14 pm

Thank you very much  :-+