EEVblog Electronics Community Forum
Electronics => PCB/EDA/CAD => Eagle => Topic started by: paulcav on March 06, 2017, 11:20:51 am
-
Here is a method of creating a 3D model of your boards
https://eagleup.wordpress.com/installation-and-setup/
-
Can it create a 3D model of a perpetual license for Eagle?
-
Hi GlowingGhoul,
This is actually a tool that existed well prior to the Autodesk acquisition so it does work with V7 of EAGLE.
Let me know if there's anything else I can do for you.
Best Regards,
Jorge Garcia
-
Can it create a 3D model of a perpetual license for Eagle?
It can't create a 3D model of that but it could probably create a 3D-printable model that simulates the new license.
-
Can it create a 3D model of a perpetual license for Eagle?
It can't create a 3D model of that but it could probably create a 3D-printable model that simulates the new license.
ROFLcopter!!! :-DD
-
Can it create a 3D model of a perpetual license for Eagle?
It can't create a 3D model of that but it could probably create a 3D-printable model that simulates the new license.
Only in fast-degrading plastic so it must be replaced every 30 days :-DD
-
Will it work with Eagle 8 licensing?
-
Hi technotronix,
It will, because the interface is based on a ULP and a Ruby plugin for Sketchup, not affected by any of the new changes.
Let me know if there's anything else I can do for you.
Best Regards,
Jorge Garcia
-
Thanks jgarc063,
I will try it with my Eagle 8. Let see if it works ok.