« previous next »
Pages: [1]   Go Down

Author Topic: polygon hatch at 45 degrees  (Read 3672 times)

0 Members and 1 Guest are viewing this topic.

Offline igeorgeTopic starter

  • Contributor
  • Posts: 42
polygon hatch at 45 degrees
« on: November 18, 2013, 10:17:25 am »
Eagle make the hatching just at 90 degrees
It is a way to make it at 45 ?
Thanks
Logged
 

Offline kizzap

  • Supporter
  • ****
  • Posts: 477
  • Country: au
Re: polygon hatch at 45 degrees
« Reply #1 on: November 19, 2013, 03:27:26 am »
Short answer, No.

Long answer, finish your board, rotate the entire thing 45 degrees then redo the polygon pour, export the gerbers, then rotate the board back to 0 degrees.
Logged
<MatCat> The thing with aircraft is murphy loves to hang out with them
<Baljem> hey, you're the one who apparently pronounces FPGA 'fuhpugger'
 
Pages: [1]   Go Up
« previous next »

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf

 


EEVblog Main Site EEVblog on Youtube EEVblog on Twitter EEVblog on Facebook EEVblog on Odysee