EEVblog Electronics Community Forum

Electronics => PCB/EDA/CAD => Eagle => Topic started by: microbug on May 18, 2013, 05:27:29 pm

Title: [solved] How can I leave holes in pads when printing?
Post by: microbug on May 18, 2013, 05:27:29 pm

Hi,
I am designing my first proper pcb with Eagle, and when I print it I set it to black so it prints out all the layers selected as pure black. This all works fine except for when I come to drill the holes and I don't always use the right size bit so my component doesn't fit well. Is there a way to print out a board but leave holes in the pads?
Thanks!

Title: Re: How can I leave holes in pads when printing?
Post by: microbug on May 18, 2013, 07:06:34 pm

It's solved now, I had to export it as an image rather than printing it directly.