Hi all,
still using Eagle 6.4 (just as info) and have a small nagging problem.
I had a large three sheet schematic and pcb and wanted to make another smaller pcb with only half of the parts.
So made a new project and I copied the old schematics to that folder and renamed it to the new project name.
Now comes the thing I am stuck with:
I moved (copy + paste) all necessary parts from the schematics pages 2 and 3 to one page 1, and then I deleted (removed) the other schematic pages (2+3).
I did a renumber parts on sheet 1 and added new parts.
What happens is that for instance I had 7 connectors K1..K7 from which K3..K7 were on pages 2 and 3 that are now deleted. I add a new connector, do a renumber parts command and the new connector gets number K8. Not K3
Manually renaming that connector works most of the time but that is pretty stupid esp. when going to 40+ resistors renaming.
Has anyone a solution for this issue?
Thanks