« previous next »
Pages: [1]   Go Down

Author Topic: How to set ground clearance in eagle?  (Read 6405 times)

0 Members and 2 Guests are viewing this topic.

Offline electrowhizTopic starter

  • Contributor
  • Posts: 28
  • Country: in
How to set ground clearance in eagle?
« on: June 27, 2018, 05:59:23 am »
I have finished my PCB design and then I gave it to one of the manufacturer. He told to change the ground clearance from 0.1mm to 0.3mm. How should I do it?
Logged
 

Offline Karel

  • Super Contributor
  • ***
  • Posts: 2217
  • Country: 00
Re: How to set ground clearance in eagle?
« Reply #1 on: June 27, 2018, 06:17:54 am »
In Eagle you set the clearances in DRC -> Clearance.

In case you are talking about a groundplane, open the Info dialog and set Polygon -> Isolate.

For more info type: help polygon
Logged
 
The following users thanked this post: electrowhiz

Offline JustMeHere

  • Frequent Contributor
  • **
  • Posts: 734
  • Country: us
Re: How to set ground clearance in eagle?
« Reply #2 on: October 03, 2018, 01:24:51 am »
Ask them if they have a design rules file.  It can help get things going.
Logged
 
The following users thanked this post: electrowhiz

Offline westfw

  • Super Contributor
  • ***
  • Posts: 4199
  • Country: us
Re: How to set ground clearance in eagle?
« Reply #3 on: November 02, 2018, 05:00:00 am »
Put your ground signal in a different signal class ("Change Class"), and then use the "class" command to specify the clearance for that class...
Logged
 
The following users thanked this post: oPossum, electrowhiz
Pages: [1]   Go Up
« previous next »

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf

 


EEVblog Main Site EEVblog on Youtube EEVblog on Twitter EEVblog on Facebook EEVblog on Odysee