EEVblog Electronics Community Forum

Electronics => General PCB/EDA/CAD Discussions => Eagle => Topic started by: alank2 on June 24, 2016, 11:45:25 pm

Title: Is there a way to take an entire component off of the tCream layer?
Post by: alank2 on June 24, 2016, 11:45:25 pm
I don't want to modify the library part if possible - is there another way?
Title: Re: Is there a way to take an entire component off of the tCream layer?
Post by: ElectricGuy on June 24, 2016, 11:55:46 pm
I don't want to modify the library part if possible - is there another way?

I don't think so!
I tried the same thing in the past, and the solution was to create a new component without that layer, based on the old component.
In this way a keep both versions
Title: Re: Is there a way to take an entire component off of the tCream layer?
Post by: alank2 on June 25, 2016, 12:56:43 am
Thanks; I'll go that route then.
Title: Re: Is there a way to take an entire component off of the tCream layer?
Post by: tomcat14 on June 26, 2016, 05:04:09 pm
Assembly Variants is what you are looking for.

Edit -> Assembly Variants in the schematic window