Author Topic: Need PCB doc converted into a gerber, paid job  (Read 3869 times)

0 Members and 1 Guest are viewing this topic.

Offline bluekingTopic starter

  • Newbie
  • Posts: 5
Need PCB doc converted into a gerber, paid job
« on: August 19, 2014, 06:29:44 am »
Hi all,

This is a PCB document for eagle. I need the components placed on the board, as referenced in the attached schematic, and the PCB converted into a gerber for sending to fabrication.

http://wikisend.com/download/346254/Archive.zip

I can offer $10 through paypal to whoever can do a good job for me. I don't have time to learn yet another CAD :)


Thanks !
 

Offline johnnyfp

  • Frequent Contributor
  • **
  • Posts: 261
  • Country: nz
Re: Need PCB doc converted into a gerber, paid job
« Reply #1 on: August 19, 2014, 06:39:12 am »
Exported as gerber.
 

Offline bluekingTopic starter

  • Newbie
  • Posts: 5
Re: Need PCB doc converted into a gerber, paid job
« Reply #2 on: August 19, 2014, 06:48:38 am »
Wow you didnt waste any time ! Did you add the components ? PM me your paypal email. Thanks !!
 

Offline bluekingTopic starter

  • Newbie
  • Posts: 5
Re: Need PCB doc converted into a gerber, paid job
« Reply #3 on: August 19, 2014, 06:53:40 am »
Is this correct ? See image
 

Offline bluekingTopic starter

  • Newbie
  • Posts: 5
Re: Need PCB doc converted into a gerber, paid job
« Reply #4 on: August 19, 2014, 06:55:37 am »
And also a little help here :)

 

Offline johnnyfp

  • Frequent Contributor
  • **
  • Posts: 261
  • Country: nz
Re: Need PCB doc converted into a gerber, paid job
« Reply #5 on: August 19, 2014, 08:05:55 am »
Don't worry about the cash, buy yourself an extra board with it, or LCD screen. I didn't have to do anything. Pcb was aleardy made.

The gerber mapping look good, the two dri drd files are the drill plots, if they ask.

Layer : 2
Dimension x : 4.41" y:3.11"

Everything else looks ok as is
 

Offline bluekingTopic starter

  • Newbie
  • Posts: 5
Re: Need PCB doc converted into a gerber, paid job
« Reply #6 on: August 19, 2014, 08:14:34 am »
Thanks bud ! My main concern is getting the LCD flex cable header on the board, and also the LT1932ES6PBF.. which I think is surface mount. I want the factory to install those, and send me a completed board, but... I figure I need to place the components in the CAD before going to gerber ?
 


Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf