Author Topic: Odd Issue: Pad diameter different in library and project  (Read 762 times)

0 Members and 1 Guest are viewing this topic.

Offline Pack34

  • Frequent Contributor
  • **
  • Posts: 504
Odd Issue: Pad diameter different in library and project
« on: August 26, 2016, 01:14:13 AM »
I made a bunch of connectors today and I'm running into an odd issue where the library entry for the part does not match the component placed in a project.

Has anyone seen this happen before? I updated the libraries and as a sanity check, changed pin1 to be square and updated again. The pad shape was updated but the outter diameter of the pad is still larger than it should be. The pads in the schematic seem to be defaulting to "automatic" but in the library these are set to a specific value.

Has anyone else run into this?
 

Offline vzoole

  • Regular Contributor
  • *
  • Posts: 117
  • Country: hu
Re: Odd Issue: Pad diameter different in library and project
« Reply #1 on: August 26, 2016, 01:33:45 AM »
I think the pads has auto diameter and in your DRC settings the pads minimum too big.
 
The following users thanked this post: Pack34

Offline Pack34

  • Frequent Contributor
  • **
  • Posts: 504
Re: Odd Issue: Pad diameter different in library and project
« Reply #2 on: August 26, 2016, 01:57:59 AM »
That was it. Thank you.
 


Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf