« previous next »
Pages: [1]   Go Down

Author Topic: Open Source Hardware Logo?  (Read 5322 times)

0 Members and 1 Guest are viewing this topic.

Offline Pack34Topic starter

  • Frequent Contributor
  • **
  • Posts: 753
Open Source Hardware Logo?
« on: August 19, 2012, 05:57:35 pm »
I'm looking at dropping a few board designs soon under OSHW and was wondering if anyone knew of a good way to get the logo on my boards.

I've seen some for gEDA but I haven't had much luck with Eagle.
Logged
 

Offline 8086

  • Super Contributor
  • ***
  • Posts: 1084
  • Country: gb
    • Circuitology - Electronics Assembly
Re: Open Source Hardware Logo?
« Reply #1 on: August 19, 2012, 06:09:13 pm »
There is one in the sparkfun eagle library.
Logged
 

Offline Pack34Topic starter

  • Frequent Contributor
  • **
  • Posts: 753
Re: Open Source Hardware Logo?
« Reply #2 on: August 19, 2012, 06:57:48 pm »
Quote from: 8086 on August 19, 2012, 06:09:13 pm
There is one in the sparkfun eagle library.

Thank you very much!
Logged
 

Offline oPossum

  • Super Contributor
  • ***
  • Posts: 1415
  • Country: us
  • Very dangerous - may attack at any time
Re: Open Source Hardware Logo?
« Reply #3 on: August 19, 2012, 07:39:01 pm »
Logged
 
Pages: [1]   Go Up
« previous next »

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf

 


EEVblog Main Site EEVblog on Youtube EEVblog on Twitter EEVblog on Facebook EEVblog on Odysee