Author Topic: Pads didn't show up in final design  (Read 917 times)

0 Members and 1 Guest are viewing this topic.

Offline electrowhiz

  • Contributor
  • Posts: 22
  • Country: in
Pads didn't show up in final design
« on: June 01, 2018, 10:37:37 pm »
I created a accelerometer PCB using ADXL335 in eagle. After finishing the schematic and board in eagle, in the final design pads were not shown for adxl335. What is the problem?
 

Offline rachaelp

  • Supporter
  • ****
  • Posts: 131
  • Country: gb
Re: Pads didn't show up in final design
« Reply #1 on: June 01, 2018, 10:49:31 pm »
You can see the shape of the pads so it looks like you turned off solder mask opening and paste mask generation for that library part but didn't manually create these layers with polygons.

Best regards,

Rachael
I have a weakness for Test Equipment so can often be found having a TEA break (http://www.eevblog.com/forum/chat/test-equipment-anonymous-(tea)-group-therapy-thread/)
 
The following users thanked this post: electrowhiz

Offline JustMeHere

  • Regular Contributor
  • *
  • Posts: 95
  • Country: us
Re: Pads didn't show up in final design
« Reply #2 on: October 15, 2018, 01:42:59 pm »
I'd move that via further to the right.  Also look into tenting them.
 


Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf