« previous next »
Pages: [1]   Go Down

Author Topic: Pads didn't show up in final design  (Read 3119 times)

0 Members and 1 Guest are viewing this topic.

Offline electrowhizTopic starter

  • Contributor
  • Posts: 28
  • Country: in
Pads didn't show up in final design
« on: June 01, 2018, 12:37:37 pm »
I created a accelerometer PCB using ADXL335 in eagle. After finishing the schematic and board in eagle, in the final design pads were not shown for adxl335. What is the problem?
Logged
 

Offline rachaelp

  • Supporter
  • ****
  • Posts: 156
  • Country: gb
Re: Pads didn't show up in final design
« Reply #1 on: June 01, 2018, 12:49:31 pm »
You can see the shape of the pads so it looks like you turned off solder mask opening and paste mask generation for that library part but didn't manually create these layers with polygons.

Best regards,

Rachael
Logged
I have a weakness for Test Equipment so can often be found having a TEA break (https://www.eevblog.com/forum/chat/test-equipment-anonymous-(tea)-group-therapy-thread/)
 
The following users thanked this post: electrowhiz

Offline JustMeHere

  • Frequent Contributor
  • **
  • Posts: 734
  • Country: us
Re: Pads didn't show up in final design
« Reply #2 on: October 15, 2018, 02:42:59 am »
I'd move that via further to the right.  Also look into tenting them.
Logged
 
Pages: [1]   Go Up
« previous next »

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf

 


EEVblog Main Site EEVblog on Youtube EEVblog on Twitter EEVblog on Facebook EEVblog on Odysee