Author Topic: [solved] How can I leave holes in pads when printing?  (Read 3829 times)

0 Members and 1 Guest are viewing this topic.

Offline microbugTopic starter

  • Frequent Contributor
  • **
  • Posts: 540
  • Country: gb
  • Electronics Enthusiast
[solved] How can I leave holes in pads when printing?
« on: May 18, 2013, 05:27:29 pm »
Hi,
I am designing my first proper pcb with Eagle, and when I print it I set it to black so it prints out all the layers selected as pure black. This all works fine except for when I come to drill the holes and I don't always use the right size bit so my component doesn't fit well. Is there a way to print out a board but leave holes in the pads?
Thanks!
« Last Edit: May 18, 2013, 07:06:52 pm by microbug »
 

Offline microbugTopic starter

  • Frequent Contributor
  • **
  • Posts: 540
  • Country: gb
  • Electronics Enthusiast
Re: How can I leave holes in pads when printing?
« Reply #1 on: May 18, 2013, 07:06:34 pm »
It's solved now, I had to export it as an image rather than printing it directly.
 


Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf