EEVblog Electronics Community Forum
A Free & Open Forum For Electronics Enthusiasts & Professionals
Welcome,
Guest
. Please
login
or
register
.
Did you miss your
activation email
?
1 Hour
1 Day
1 Week
1 Month
Forever
Login with username, password and session length
This topic
This board
Entire forum
Google
Bing
Home
Help
Search
About us
Links
Login
Register
EEVblog Electronics Community Forum
»
Electronics
»
PCB/EDA/CAD
»
Eagle
»
Ripup the traces after applying the ratsnest command in Eagle
« previous
next »
Print
Search
Pages: [
1
]
Go Down
Author
Topic: Ripup the traces after applying the ratsnest command in Eagle (Read 4856 times)
0 Members and 1 Guest are viewing this topic.
rithi3
Newbie
Posts: 7
Ripup the traces after applying the ratsnest command in Eagle
«
on:
December 18, 2012, 07:18:38 am »
How to ripup the traces of a net (Say want to delete all the Gnd net traces) after the ratsnest command applied?. I tried & couldn't delete the traces. Plz help me.Thanks!!!
Logged
funk1980
Contributor
Posts: 17
Re: Ripup the traces after applying the ratsnest command in Eagle
«
Reply #1 on:
January 17, 2013, 08:29:23 pm »
You remove traces with the ripup command (or button). The actual airwires (yellow lines) are a direct result of the schematic the PCB is based on.
Logged
oyvdahl
Newbie
Posts: 8
Country:
Re: Ripup the traces after applying the ratsnest command in Eagle
«
Reply #2 on:
January 22, 2013, 12:59:12 pm »
As funk1980 says, use the ripup command.
You can specify a net as well if you's like: RIPUP GND
Logged
Oyvind
www.build-electronic-circuits.com
Print
Search
Pages: [
1
]
Go Up
« previous
next »
Share me
Smf
EEVblog Electronics Community Forum
»
Electronics
»
PCB/EDA/CAD
»
Eagle
»
Ripup the traces after applying the ratsnest command in Eagle
There was an error while thanking
Thanking...
EEVblog Main Site
EEVblog on Youtube
EEVblog on Twitter
EEVblog on Facebook
EEVblog on Odysee