After a long Easter delayed trip from E14's UK warehouse the extra 12V transformer and Cap arrived so I could play a game of Heavy Metal Tetris. Even when I ordered the extra bits I thought it would be tight but reality was a lot worse.
Move all the bits possible vertically out to the top and bottom Aluminium perforated panels to improve volume, make a custom Acrylic mount for the Caps, cut, grind, chop, sand and nibble my way to a resolution including fitting a cheapy Chinese mains power meter into the front panel. I could have most likely skipped or shrunk the heatsink for the Rectifiers but there is potentially 20+W to dissipate. The Switched Bleeder resistors (circa 40-50 second) for the caps double up as current reduction for the front panel LED's (1k, 2.2k and 4.7K). All outputs are electrically isolated at this stage.
I should have ordered some other coloured cable but Red and Black 16AWG it is and fairly straight forward wiring to followif needed. Doubled up the output pins on the Amphenol connector as they are only rated to 5A each. 6.5kg btw is the weight of this bit
Will boot it up tomorrow and have a look on the scope. Next bay is the LiPo charger