Low Cost PCB's Low Cost Components

Author Topic: NL: Need a small change in existing Altium file  (Read 372 times)

0 Members and 1 Guest are viewing this topic.

Offline nctnico

  • Super Contributor
  • ***
  • Posts: 12732
  • Country: nl
    • NCT Developments
NL: Need a small change in existing Altium file
« on: September 07, 2017, 03:07:24 AM »
I'm looking for someone who can make a small change (adding a small RF connector) to an existing (open hardware) design. The existing design is an 8 layer board with a big FPGA. I prefer someone located in the Netherlands so we can meet face-to-face to explain what is needed.

Edit: found someone!
« Last Edit: September 13, 2017, 09:44:25 PM by nctnico »
There are small lies, big lies and then there is what is on the screen of your oscilloscope.
 


Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf