Hi all.
I have a small problem where I personally can't solder or reflow small fine pitch FPC connectors or a 20 pin TSSOP.
So looking for someone who can run them through a P&P machine or do the boards by hand, or both?
I have 4 types of boards in total though 3 are group together and have the same components as the single board other than a set of FPC components.
The single board has 19 components, the 3 grouped boards have 29 (the extra 10 made up of a duplicate set of 4 components and FPCs).
Ill supply all the components on cut tape, reel and tube.
I just need a rough estimate for now.
Thanks
Jack,