Traces and copper pour going through pads

[sentry7]

Hey guys,

First-time KiCad user, and I am nothing short of impressed so far.

Question about the copper layer. So I have a simple dummy design here, and I've included a grounding plane on the top layer. When I hide the top pads, it shows copper pour and traces going through places where drilled holes would be. It even shows up on the 3D view. What's going on here?

[MarkS]

It is the way that KiCAD draws the polygons internally, although the 3D view is clearly a bug and needs to be fixed. This will not impact a finished board.

[Caio Negri]

Shouldn't make a difference in the manufacturing process since pads and traces get merged in the same gerber file anyway. 3D view should definitely not display that but I guess that is a low priority bug.

[Deridex]

I gotta agree on what the other 2 guys said:
While it seems to be a bug in the 3D view, i doubt it has any impact on the manufacturing process.

[richardlawson1489]

What is the solution to solve this bug in 3D view?

[QuantumLogic]

In the 3D Viewer, go to Preferences-->Render Options and make sure "Show holes in zones" has a check mark to the left of it.