assembly od sma stainless steel connector

[sdouble]

Hi all,
I intend to develop a board which will include a bunch of SMA connectors.
My plan is to go for stainless steel connectors instead of standard brass ones.
Would you know if that choice could lead to any problem in the assembly phase ?
the connectors will be rather similar to that one :
https://www.ebay.com/itm/20x-SMA-RA-thru-hole-female-jack-bulkhead-O-ring-right-angle-PCB-Mount-Connector/273166220321?hash=item3f99f9bc21:g:8SsAAOSw4GVYPU0R
but SS made and unplated.

thanks for your feedback