different color silkscreen

[riktw]

Hello,

I saw the PCB of the Mojo FPGA board on adafruit and what immediately got my attention was the black PCB with green silkscreen.
It really looks wonderful and I would like to know if there are PCB manufacturers who can make this?
http://www.adafruit.com/products/1553

Best regards,

Rik

[mikeselectricstuff]

Most manufacturers will do any colour combination you want, but there may be a 1-off cost, and possibly a minimum if they need to get a special ink in.

[KJDS]

I used to use different coloured solder resist when I had two very similar boards on a production line at the same time. When the only difference in the boards is a couple of different resistor values it made for easy identification. Most board manufacturers can offer a range of options, but unless you are buying a lot it will cost.

[kizzap]

Last time I used a custom colour PCB I used goldenphoenix to get a panel made. Decent quality, and isn't all that expensive. Lead time wasn't too bad either.

-kizzap