Housing/Enclosure

[EEVaditya]

Hello,

Need Housing/Enclosure for vehicle (dashboard) mounted walkie talkie. (See attached photo for reference).
The enclosure should have provision for volume knob & power button.
And slot for wires (preferably at the back side of enclosure)
Display and key not required.

[EEVaditya]

Hello,

Where will I get such enclosure??? any suggestions

[SMdude]

Nope, you have to get a design done, a mould made and someone to injection mould it.

It will be a very cost prohibitive process...

You can try globalsources, but at minimum you will need a 3d cad design, or you wil not get what you want.

[Mr. Scram]

Another route might be to have an existing enclosure adapted to your needs by the manufacturer. I know some Chinese outfits will do this.

[phil from seattle]

Well, you could 3D print one.

In general, it's a good idea to pick out your case before you design the PCB.

[EEVaditya]

Hello,

Can I get readymade enclosure or housing and then I can cut or make provision of slots for volume knob and power button and wires

Can I get such enclosure which will look suitable shapewise for walkie talkie and then rest I can make changes according to my need

[Mr. Scram]

Hello,

Can I get readymade enclosure or housing and then I can cut or make provision of slots for volume knob and power button and wires

Can I get such enclosure which will look suitable shapewise for walkie talkie and then rest I can make changes according to my need

Have you looked at something like this? No affiliation.

https://www.aliexpress.com/store/1352312

[EEVaditya]

Hello,

I saw the suggested models on Ali express. But these housings gets open in two pieces(two parts). I want single piece housing. The housing should not be an attachment of two parts , it should be single continuous housing.

[EEVaditya]

Any solution

[Mr. Scram]

Any solution

Can you show what you have done to solve your question so far?

[JPlocher]

Your posts imply a desire for someone will come up with a product for you to buy - I hope you realize that this is a general discussion forum and not a design service or a front for a vendor who can sell you anything...

  -John

[Raj]

Can you use seal-able bag?