Looking for calibration procedure for an ESI Video bridge 2150.

[1audio]

I have 2 ESI 2110's and an ESI 2150. I have the manual for the 2110 but the 2150 is enough different that the cal procedure probably is not the same and the test points and trimmers are certainly different. Does anyone have the procedure or a scan of the manual they can share? I have found very little on the 2150 version but a complete scan of the 2100 version on line.

[picburner]

I have a good old ESI 2160 and the paper service manual of 2150/2160.
I did a scan of section 4 only, "Performance, Calibration and Maintenance" but it is a bit too thick to put here (about 14MBytes).
I can put it on the KO4BB website or send it at your email address.

BR

[ap]

Putting these things on KO4BB is always a good solution.

[1audio]

I agree. Send to me (I'll pm my e-mail) and send to KOBB since the odds of me losing it are pretty high over time.

[picburner]

For those interested in this service manual I sent 4 sections of the same to the KO4BB site.
As soon as I find the time I will complete the work.