Wasn't sure where else to discuss this so I'll give it a shot here. Lattice technically doesn't support it (Fedora or Suse only) so they aren't going to be helpful.
I am running Ubuntu 14.04 64-bit. Installed Lattice Diamond 3.2.0.134. I had a few minor hiccups with libraries and licensing, but got it running. The issue I am having is that diamond doesn't seem to have any supported devices. If I create a new project, when the dialog pops up to select a device it is blank. Likewise if I open an example project it always says that XXXX device is unsupported. So it seems to be failing to open some device list file.
Anyone have any ideas here or hopefully have figured it out? The program doesn't seem to generate any debug output anywhere that I can find. I have been stracing it to try to figure out what is going on but haven't found any hints yet.
I suppose I could run it in a VM but that is definitely less desirable. I am sure this is something fairly minor but so far I can't find any clues as to what it is.